Maintenance

How to Winterize an RV, Step by Step

A note before you follow this guide: Some details here are common rules of thumb, not laws or a substitute for your RV's owner's manual, the tire or roof manufacturer, or a qualified technician. Pressures, tire age, sealants, walking on a roof, and towing capacities vary by rig. When in doubt, follow the manual or get professional help.

If you live anywhere that freezes, winterizing your RV isn't optional. Water left in the lines, the water pump, or the water heater can freeze, expand, and split pipes and fittings. Those repairs are a miserable way to start the camping season, and they're almost always avoidable.

I've winterized RVs every fall for decades. This is the process I follow. It takes an hour or two the first time and less once you've done it.

Before you start: always check your RV owner's manual. Some RVs have specific steps for things like ice makers, washers, outdoor kitchens, or special water heaters, and the manual wins over any general guide, including this one.

What you'll need

  • RV antifreeze, the pink, non-toxic kind made for potable water systems. A typical trailer often uses about 2 to 3 gallons, but larger rigs with more fixtures may use more. Buy an extra jug.
  • Never use automotive antifreeze. It's toxic and does not belong in your fresh water system.
  • A water heater bypass (most RVs have one built in; if not, a bypass kit can be installed)
  • A pump converter kit or siphon tube so the water pump can draw antifreeze straight from the jug (many RVs have a built-in winterizing valve for this)
  • Basic hand tools, and the right socket or wrench for your water heater drain plug or anode rod
  • A water heater anode rod if yours uses one and it's worn, or a new plastic drain plug if yours uses that type
  • Gloves and a few old towels

Step 1: Empty and flush the holding tanks

Dump the black tank first, then the gray tank. If you have a tank flush system, use it to rinse the black tank. You want both tanks empty before winter.

Step 2: Drain the fresh water tank

Open the fresh water tank drain and let it empty completely. Leave the drain open until you're done.

Step 3: Drain the water heater

Turn off the water heater, both the electric element and the propane, and let the water cool completely. Never drain a hot water heater.

Then:

  1. Turn off the water pump and disconnect from city water.
  2. Open a hot water faucet inside to relieve pressure.
  3. Open the pressure relief valve on the water heater.
  4. Remove the drain plug or anode rod, depending on your water heater, and let it drain completely.

This is a good time to inspect the anode rod if you have one. If it's badly eaten away, replace it in the spring.

Step 4: Open the low-point drains

Find your low-point drain lines, usually under the RV near the middle, one for hot and one for cold. Open them and let the lines drain. Open all the faucets, hot and cold, inside and outside, to help the lines drain fully. Flush the toilet to drain its valve.

Once everything has drained, close the low-point drains and all the faucets. Put the water heater drain plug or anode rod back in.

Step 5: Bypass the water heater

Set your water heater bypass valves to the bypass position. This keeps antifreeze from filling the water heater tank, which can take six gallons or more and would waste a lot of antifreeze.

Step 6: Hook up the antifreeze

Either:

  • Turn your RV's winterizing valve so the water pump draws from a siphon tube, and put the tube in a jug of RV antifreeze, or
  • Install a pump converter kit on the inlet side of the water pump and put its tube in the jug.

Step 7: Pump antifreeze through every line

Turn on the water pump. Then, starting with the faucet closest to the pump and working your way to the farthest one:

  1. Open the cold side slowly and let it run until you see solid pink antifreeze. Close it.
  2. Open the hot side and do the same. Close it.
  3. Repeat at every faucet in the RV, including the kitchen, bathroom sink, and shower.
  4. Don't forget the outdoor shower or outdoor kitchen if you have one.
  5. Flush the toilet until you see pink in the bowl.

Switch to a fresh jug when one runs low so the pump doesn't suck air.

Step 8: Protect the drains and traps

Pour a cup or so of RV antifreeze into each sink drain and the shower drain. This protects the P-traps. Pour some into the toilet bowl and flush it into the black tank to protect the tank valve.

Step 9: Don't forget the extras

Many RVs have extra water lines that need special attention:

  • Ice makers and washers: follow your owner's manual. These often have their own winterizing steps.
  • City water inlet: some people push a little antifreeze through the inlet check valve by removing the screen and pressing the valve. Check your manual.
  • Water filter housings: remove the filter cartridges and drain the housings.

Step 10: Shut down and prep for storage

  • Turn off the water pump.
  • Make sure the water heater is off.
  • Leave a note on the dash or the faucet that says "Winterized. Do not use water."

The compressed-air method

Some people prefer to blow the water out of the lines with compressed air instead of, or in addition to, using antifreeze. You'll need a blowout plug that threads into your city water inlet and an air compressor.

The key is to keep the air pressure low, often cited around 30 to 40 psi or less, because too much pressure can damage the plumbing. Check your RV manual for any limit it gives. Open each faucet, hot and cold, one at a time until only air comes out, and flush the toilet until the valve runs dry.

Air alone can leave small amounts of water in low spots, traps, and the pump. In very cold climates, many owners blow out the lines and then also add antifreeze to the traps and pump for extra protection.

Common winterizing mistakes

  • Forgetting the bypass and filling the water heater with antifreeze
  • Skipping the outdoor shower or other outside fixtures
  • Using automotive antifreeze in the fresh water system
  • Waiting too long. One hard overnight freeze can do the damage. Winterize before the first freeze is forecast, not after.
  • Leaving the water heater drain plug out and then forgetting about it in the spring

De-winterizing in the spring

When it's time to camp again:

  1. Remove the antifreeze source and return the pump valve to normal.
  2. Fill the fresh water tank or connect to city water.
  3. Run every faucet, hot and cold, until the water runs clear with no pink.
  4. Take the water heater out of bypass, let it fill completely, and only then turn it on.
  5. Sanitize the fresh water system if your manual recommends it.
  6. Check for leaks at every fitting.

A few storage tips while you're at it

Winterizing is a good time to get the whole RV ready for its rest. Clean out the fridge and prop the doors open so mold doesn't grow. Remove food that could attract mice, and close up any gaps where they might get in. Charge the batteries fully and either keep them on a maintainer or disconnect them, following your battery maker's guidance. Turn off the propane at the tank. And if you can, cover the tires to protect them from the sun.

The bottom line

Winterizing is simple once you've done it, and it's far cheaper than replacing split water lines. Pick a dry fall afternoon, follow the steps, and your RV will be ready to go next spring.

For a printable, large-type version of this process with checkboxes, plus a spring de-winterizing checklist and a full-year maintenance schedule, grab the RV Maintenance & Winterizing Kit in the shop.

Looking at a used RV right now?

Dave's $199 written valuation and $99 video consult are coming soon. Join the waitlist and we'll let you know when you can book.

Join the waitlist

Not a certified appraisal and not a physical inspection.

Some links in articles may be affiliate links. If you buy through them, we may earn a commission at no extra cost to you. Learn more. This article is general information, not professional advice for your specific RV; always follow your owner's manual and manufacturer guidance.